Posts Tagged ‘dialup’

A small update to the cellular browsing

Wednesday, July 2nd, 2008

I have uploaded a replacement¬†wvdial.conf for the cellular entry below. Notice that for Cellcom in Israel, you need an init string AT+CGDCONT=1,”IP”,”internetg” . which is embedded into the file. For other cellular providers, you might need a different string.

For Cellcom users out there – this is the right init string. If you are on an “Cellular Internet” package, do not use AT+CGDCONT=1,”IP”,”WAPU” !

A nice dial-up script

Tuesday, July 1st, 2008

It’s either me, or NetworkManager sux. This is the most incomplete and incompetent piece of software I have ever seen. The only reason I actually use it is that there is no better alternative which does whatever NetworkManager manages, somehow, to do.

My initial thought was to setup NetworkManager as the dial-up component. What should be more obvious than that? Well, it just won’t connect, and its logs are horrific at best. So back to gksudo script for us, then…

You can put this script cell.sh in /usr/local/sbin/ and change its permissions to eXecutable (by root, of course), and then add a nice menu item called “Cellular Internet” in your Gnome Menu. It should run ‘gksudo /usr/local/sbin/cell.sh

That’s all.

Sierra AirCard 880E on Ubuntu

Tuesday, July 1st, 2008

To get your newly purchased Sierra AirCard 880E on your Ubuntu Hardy, you should follow these simple steps:

  1. Make sure you have GCC on your computer: ‘sudo apt-get install gcc
  2. Make sure you have kernel sources installed on your computer: ‘sudo apt-get install linux-headers-2.6.24-19-generic
  3. Download the driver from Sierra Wireless site
  4. Extract and compile (‘make‘, ‘sudo make install‘)
  5. Add to /etc/modprobe.d/blacklist-modem the line: ‘blacklist ehci_hcd’
  6. Insert the device into the laptop. When everything is OK, you should see that a USB device is registered using ‘dmesg‘ shortly afterwards, or ‘lsusb
  7. Configure /etc/wvdial.conf using the attached config file wvdial.conf
  8. Add to /etc/ppp/peers the file wvdial

Done. To connect, you need to run ‘sudo wvdial &

I will add in the future a nice gksudo with a nice-looking connect/disconnect script